Although the belt dryer is more efficient and energy-saving dryer, but in practice there will be a breakdown, what we do is to find out the cause of the malfunction to exclude, let the belt dryer for maximum energy efficiency for us service. Therefore, when customers buy belt dryer, pay attention to the configuration of the dryer, belt dryer filter on the selection and selection to be compatible with the drier tooth channel and aperture, the general selection of filter mesh diameter is dry Machine into the channel or aperture can be 0.2 times. Belt dryer in use what are the common faults? How to solve? How to maintain it? Kuwait professionals to tell you a few points:
1, check the air source before the start of triplet, will be discharged and to ensure adequate water level.
2, to ensure that the dryer has a good grounding equipment, the temperature of the instrument should be measured after the test.
3, the parts for inspection and maintenance, such as bearings plus lubricants, adjust the pulley, check the electrical lines, door rocker, pipe connections, etc. and fixed.
4, raw materials, fire failure, equipment design may be dryer problems, or raw materials led to the smoke led to the fire and so on. In addition, may also be caused by human factors, such as in order to achieve the drying effect of too small dryer forced heating caused a fire. At this point the best replacement dryer equipment, check the dryer is installed correctly, whether to leak or increase the wind pressure. Correct use of dryers, be careful to increase the temperature of the dryer, so as not to cause a fire.
     5, a one-time raw materials do not bother, this is mainly due to the dryer is too small or improper use of dry and other causes. In addition, wind pressure, flow calculation errors can also lead to such a failure. You can change or re-modify the drying equipment, or require manufacturers to recalculate wind pressure, flow and other changes in the program. If it is caused by improper operation, then the operator in strict accordance with the instructions for proper operation.
     6, to ensure that the base frame bolts are not loose, elastic support spring connection appropriate computer board control, rotor, heat exchanger has a good flexibility.
     7, keep the equipment clean, wipe the equipment daily, cleaning the dust inside the dust box to ensure ventilation and so on. Periodically open the lid after cleaning the inside of the device.